Step by Step Guide on How to Change a Car Tire. There is never a good time for a flat tire but it better to be prepared for one. changing a tire might be stressful but it necessary for every driver to know how it’s done. It is good to know how to change a car battery but it’s better to maintain your tire by adhering to precautions like.
- Making sure tires are well inflated
- Avoid roads with debris
- Monitor tires for tread wear
these and many other precautions can be observed to extend tires life span and reduce the probability of a flat since there is no way to prevent a flat.
It’s beneficial to be able to change your tire by yourself, should in case you find yourself in a situation whereby you have a flat tire and no vulcanizer in the site. Changing your flat tire will take you not more than 30 minutes as an amateur.
Below is the step by step instructions on how to change a flat tire, gracefully you would be able to change your tire by yourself if follow the steps properly.
Changing a car tire requires the use of some tools these tools are listed below.
- Lug wrench
- Inflated spare tire
- Wheel wedge
- Rain poncho
After getting all tools now you get to the main issue (learning how to change a flat tire)
Steps on how to change a flat tire
Kindly follow the step below to Change a Car Tire
Find a conducive parking space
Immediately you notice a flat tire, to change a Car Tire gently slow the vehicle down and look for an ideal location where you can park your car. (most times a parking spot is the best to do the work).
Turn hazard light on
Hazard lights will notify other road users that you are on the road. turn flashers or hazard lights on to prevent accidents.
Put vehicle on park
Do not commence repair if your car is on acceleration. Make sure your car is placed on parking to prevent the car from moving during the process of changing the tire.
Use tire wedge
After parking your car make use of wheel wedges. Wheel wedges can be placed at the front or behind the vehicle tires depending on which tire you are fixing. If the front tire is bad to put wedges at the rear tires but if rear tires are badly put the wedges at the front tires, to avoid tire rolling.
Remove the wheel cover and loosen the lug nut
Take wheel cover out of the tire if your wheel has one. After that, use the lug wrench to loosen the lug nut. Turn the lug nuts anti-clockwise to loosen their resistance but do not lose completely.
Place the jack beneath the vehicle
There is a flat part under the vehicle, its the appropriate place for the jack. Many vehicles have a special place beneath that is made of metal for the jack to be placed. If you are finding it hard to locate the metal part use the vehicle manual to find it.
Raise the vehicle with the jack
Use a scissors jack if you have one, put the wrench over the knob and crank, if it is a hydraulic jack insert the handle in the right position after that pump the jack-up and down until the flat tire is six inches away from the ground.
Remove the flat tire
Unscrew the lug nuts completely with your bare hands since you loosen it already. Now, draw the tire out towards your direction with your two hands until you can finally hold it.
Fix the new inflated tire
Now put the spare tire in lug bot, push it in until you can see the bolts through the rim from the other side. put the lug nuts with your hand in each lug bot and don’t tighten it completely.
Bring the vehicle down to the ground
Turn the jack anti-clockwise to get the vehicle to the ground after which you use the wrench. To tighten the lug nuts by turning it in a clockwise direction.
Replace the wheel cover
If the wheel cover will fit the newly fixed tire do well to fix it to the wheel the same way it was on the flat tire. Check if the pressure of the new tire is up to the normal gauge, the normal pressure of a tire is 60 psi. If not make sure you inflate to its normal pressure. Now you have done to check all the tools and put them back in their rightful positions.